post op xray after a laterjet procedure

Laterjet Shoulder Surgery Recovery: One Year Later

In April of 2024, I had surgery to repair a recurring shoulder instability. Though my shoulder has been an on-and-off again issue for years, repeated sublaxations and dislocations had taken a toll, and it had gotten so bad that I couldn’t even reach for things without fear of a dislocation.

The preoperative diagnosis was a “shoulder recurrent instability and partial thickness rotator cuff tear, so I went in for an arthroscopic shoulder surgery. Once the surgeon was in with the arthroscope, they discovered a large Hill-Sachs lesion on the humerus and an absent anterior labrum. The bicep tendon was tendinopathic, and the underside of my rotator cuff had a tear. That’s the technical stuff. Basically, my shit was way more messed up than they previously assumed. It turns out, dislocating or sublaxing your shoulder almost 20ish times shreds the heck out of important bits, and there wasn’t anything there to repair. Fortunately, there’s a medical solution!

The repair consisted of a biceps tenodesis and an open Laterjet procedure. From what I understand, the Laterjet is essentially the “nuclear option” when there isn’t another fix. They essentially create a “bone block” that keeps the shoulder from moving out of its happy place.

After cutting a hole in the back of my shoulder and poking around with a camera and doing the bicep tendinitis, they sewed it up and came in from the front. Making a 5-6cm slice into the shoulder, and dissecting it, they move the deltoid, and “retract” the pectoralis major.

They cut off a piece of the coracoid bone and its attached tendon, drill two holes in it, and screw it to the front of the shoulder socket. By grafting the small piece of the coracoid and its attached tendon to the front of the glenoid with screws, it acts like a “bumper” to keep the shoulder joint from dislocating.

Fuck man, science! I’m just stoked it works.

My shoulder has been an on-and-off again issue for years, but for the most part, I’ve just learned to deal with it, and while it created some limitations, I didn’t want to incur the time and financial costs of a repair, and just kept on keeping on.

However, two summers ago, I blew it out with a dislocation on a step-down jump, and whatever was left to keep my shoulder in place was apparently gone. Over the next year, I experienced over a dozen more dislocations and sublaxations. At least two of those times were a result of just reaching for something. Those were probably the most mentally taxing. I couldn’t even reach out and grab the handle of my car door at this point. Feeling the ball of my shoulder slide out while doing day-to-day tasks was frustrating and depressing, and it was clear it was time to invest in a hopefully permanent medical solution.

How it started: DH Practice and the orange rock

The first time I dislocated my shoulder was in college years ago, while doing practice runs on a grassroots downhill mountain bike race near Eugene, Oregon. We had come out and done runs once before, but on this day, something changed. As I was charging down the trail, my eyes caught a glimpse of a bright orange object. Someone had the idea to spray paint some large rocks on the trail to mark them; however, all it did was draw my eye to them. Naturally, I ride right where I was looking and I plowed directly into the square-edged rock deflecting me off the trail towards a tree. Making it worse, due to the wet conditions, my grips were already loose on my bars. (this was before bolt-on grips were commonplace; back then we had to use safety wire to secure our grips – unfortunately, I didn’t have mine set at this time as the grips were still new-ish)

Upon impact with the orange rock, my hands came off the handlebars — with the grip still grasped in my hand. My momentum carried me head-on into a tree. I was lucky in that I was able to twist my body in such a way that I avoided hitting it headfirst in what could have been a fatal injury. My shoulder wasn’t so lucky, though.

I became aware of dirt in my mouth on the ground a few seconds later. Then I realized my left side was in pain and I couldn’t lift my left arm. I’m not even sure I could get up, much less roll over. I recall friends helping me up and extricating me from my bike.

With help, I limped down to the bottom of the course. As there wasn’t anyone on hand capable of first aid, I received a long ride to the emergency room. My shoulder was on fire at this point – having your arm out of its socket hurts, and every bump was painful. With the long period of it being out of its socket, what I recall of the reduction was painful.

I went years without dislocating my shoulder after that initial incident. However, once a shoulder comes out, it is easier to sublax it or dislocate it again. I experienced a number of sublaxations and full dislocations over the years until the big one. After that, it was officially destroyed and I finally took the time off for the repair.

One year later

It’s been a year and almost six months since I went under the knife, and I’m in a very different place with new challenges, goals, and aspirations. They did a great job; I had no complications, and my range of motion is better than it’s been in years. The best part is I can reach above my head, and I no longer have that feeling that my shoulder could dislocate. I’m doing pull-ups for the first time since I can remember – albeit weight-assisted ones. I still have a way to go in building back strength.

I did my rehab, went to PT, and joined a gym. I got laid off while on paid leave, which was an interesting experience. On the upside, I had the time to heal, as well as acquire a whole new skillset during my sabbatical from a 9-to-5.

My shoulder works better than it has in years, and while I’m riding again, I find myself to be not only cautious but paranoid about reinjury. I’m officially middle-aged, and with that comes a new perspective. My goal is to age well and be an athlete, which means strength training is a regular part of my life now, with a greater emphasis on weights and gym work than cycling endurance. My personal goals are focused on building strength and mass so I’m better prepared for that inevitable impact with the ground — mountain biking does involve risk, especially when you enjoy black diamond technical trails and jumps. My shoulder feels good riding, but when I’m riding black diamond steeps, I’m aware that on steep pitches, I don’t feel as strong as I want them to be, and the thought of crashing because my body isn’t strong enough for an impact keeps me focused at the gym. I didn’t think like that before though, so this is a new thing. Taller handlebars make a difference on hard impacts, and I’m starting to switch to 50mm bars on bikes I ride on this type of terrain.

I think that many mountain bikers just ride without training specifically for the sport outside of endurance. My main goals are to get and stay fit enough for big days of adventures, regardless of the terrain or type of activity. The shift in my training goals has been eye-opening and transformative. It turns out that when you aren’t burning thousands of calories on long bike rides, your body can actually build muscle. I’m constantly trying to learn more about training and how my body responds. I’m at the gym two days a week, but would like to make it at least three. What’s interesting is my weight gain. I’m easily 15lbs heavier than I’ve typically been, and I’ve had to purchase new dress shirts for work due to the increased mass in my chest and shoulders.